Burgertime Card Edge Pinouts (Note 1)
Main Board
Parts
Side		 Data
East		 Bally /
Midway		 Solder
Side
GND 1 18 GND
GND 2 17 GND
Speaker/GND 3 16 GND
Speaker 4 15 Tilt/Slam
1-Right 5 14 2-Right
1-Left 6 13 2-Left
1-Up 7 12 2-Up
1-Down 8 11 2-Down
1-Pepper 9 10 2-Pepper
  10 9  
1-Start 11 8 2-Start
  12 7  
key-key-key key key key-key-key
Coin 13 6 Coin
  14 5  
Test #1 (Note 2) 15 4 (Note 3) Test #2
-5V 16 3 -5V
+5V 17 2 +5V
+12V 18 1 +12v
Sound Board
Parts
Side		 Data
East		 Bally /
Midway		 Solder
Side
+5V 1 10 +5V
+5V 2 9 +5V
+5V 3 8 +5V
H.Sync 4 7  
V.Sync 5 6  
Red 6 5 Green
Blue 7 4 (Note 4) C.Sync
GND 8 3 GND
key-key-key key key key-key-key
GND 9 2 GND
GND 10 1 GND

Note 1: Bally/Midway and Data East use opposite numbering and letter schemes for identifying the edge connector (eg. 1 versus 18, and A versus B).

Note 2: Wired in parallel with Dip SW1 pin5.
Note 3: Wired in parallel with Dip SW1 pin6.
Note 4: Bally/Midway boards do not have the composite sync output wired to the edge connector. The composite sync output can be found at pin3 of chip 9H (7486).